Pneumatic version;

Delivery: 49 cc.

Tank capacity :1 liter

Oil distribution ratio :25/1;

Maximum speed :40 km/h;

Itinerary: about 20 km;

Start: manual start;300 yuan for electric start

Tire: 4-inch rubber wheel;

Carrying capacity :85 kg;

Size of outer case :104*68*52

An electric version;

Number of wheels :4

Charging times :>350-400 times

Speed: 20km/h (national regulated speed)

Maximum distance :10 km

Net/gross weight :25/28kg

Motor power :300W

Battery capacity :12AH24V

Weight: 50 kg

Input voltage :220V

Carton size :104x62x58cm


 

The vehicle long;Height: 50 cm front and rear wheelbase: 70cm off the ground :15(cm)

Reminder: car maintenance and maintenance is very important, do not forget to add oil, early do not make the engine high-speed operation

Vehicle distribution: tool bag, mixing pot (with mixed oil)


 

The picture is pneumatic version

Frequently asked questions:

A. if the ignition is laborious, there are several reasons:

First, pull up the damper switch, so that the ignition is a lot easier. After pulling, be sure to pull down the damper switch, or it will cause stupor, there is not enough air in the engine, gasoline and oil combustion is not sufficient, it is easy to extinguish.

Second, more oil will appear smoke, old flameout phenomenon, buyers see, be sure to be proportionally configured: gasoline to oil ratio: 25-30:1, oil for the two special oil!

Third, the buyer may buy the oil quality is not good, too many impurities, the carburetor to plug, resulting in gasoline can not come down, the engine oil is not sufficient, at this time you can remove the carburetor, and then use unused gasoline cleaning


 

Fourth, the waiting number (located in the left side of the carburetor) is too low, use a word screwdriver to adjust the idle number, turn half grid clockwise.

B.If the buyer finds oil leaking from the carburetor after receiving the carburetor, it is mainly because the car is turned upside down during transportation, and the white oil float in the carburetor gets stuck, causing the gasoline to be discharged from the exhaust pipe.Solution: remove the carburetor and adjust the white float.Then press the oil needle down.This can effectively avoid the occurrence of oil leakage.